a. Turn the Bypass Key clockwise and hold it for at least 1 second. Note: to prevent unauthorized use of the saw in Bypass Mode, remove the Bypass Key from the saw when not in use.
b. While still holding the Bypass Key turned, pull the Start/Stop paddle out to the ON position.
The blade will start to spin and the Bypass Mode status code will flash on the LEDs.
c. Continue to hold the Bypass Key turned for at least 1 second after the motor starts. If you release the Bypass key before 1 second has elapsed, the motor will stop and the “Switch Start/Stop Paddle to OFF” error code will be displayed. If this happens, switch the Start/Stop paddle to OFF and repeat this procedure from the beginning.